Cart is Empty
Close
Categories
Recently Viewed
Help
Promotions
Special
Special Offers
Parts Ordering Tips
Parts Ordering Tips
Burners
- To find the correct burner (and venturis, if required) for your grill, you will first need to determine the burner’s type: H-Shaped Single, H-Shaped Twin, Oval Single, Oval Twin or Triple, Figure-8, Pipe, Ring, Rotisserie, or Table-Top.
- Pipe, ring, and table-top burners do not require venturis. All other burners are shown with veturis.
- Burners depicted as gray, unless otherwise noted, are made of cast iron. Other burners, except as noted, are stainless steel.
- Critical Dimensions: The critical dimension for heat plate fit is determined by the way the plate mounts in the grill housing. Most plates mount front and back, so for these plates this dimension (depth) is critical. A significant minority of plates, however, mount left and right. For these plates, the width dimension is critical. We list heat plates in descending order of the critical dimension, so to find a replacement part, you must first make note of how the original part mounts in your grill, front and back or left and right.
- As a general rule, the critical dimension measurement for a replacement heat plate must be within three sixteenths of an inch (0.1875”) of the original part in order to fit correctly. You should measure your grill to make sure the replacement plate will fit before buying a part with a critical dimension different from that of the original part.
- The other dimension of a heat plate is much less critical. A replacement can be a few inches narrower or shorter than the original and still be useful.
